Order Products : sales@su-jiao.com

Shin-Etsu Elastomer KEG-2001-50A/B

Category:	Silicone Rubber, HTV , Silicone Rubber, HTV
Manufacturer:	Shin-Etsu Silicones of America
Trademark:	Shin-Etsu Elastomer
Fillers:	-
Ports:	Qinzhou, Shekou, Shanghai, Ningbo
Delivery Terms	FOB, CIF, DAP, DAT, DDP
PDF:	g6VQFv_Shin-Etsu-Elastomer-KEG-2001-50A-B.pdf
PRICE:	Order Products email sales@su-jiao.com

Wechat: WECHAT

Message
Shin-Etsu KEG-2001-50 is a very fast cure liquid injection molding silicone. It is supplied as two components which are mixed in a 1:1 ratio to ensure easy and accurate blending. The viscosity of KEG-2001-50 is low enough to allow easy pumping through most injection molding systems. High tear strength Rapid cure time at elevated temperature Long pot life at room temperature Typical Applications O-rings. Diaphragms. Capping. Rubber rollers. Connector packings. Other electrical parts.

Message

Shin-Etsu KEG-2001-50 is a very fast cure liquid injection molding silicone. It is supplied as two components which are mixed in a 1:1 ratio to ensure easy and accurate blending. The viscosity of KEG-2001-50 is low enough to allow easy pumping through most injection molding systems.

High tear strength

Rapid cure time at elevated temperature

Long pot life at room temperature

Typical Applications

O-rings.

Diaphragms.

Capping.

Rubber rollers.

Connector packings.

Other electrical parts.

General Information
Features	Low viscosity Workability, good Fast curing Good tear strength
Uses	Electrical components Diaphragm Roller Shield Connector
Agency Ratings	ISO 10993 Part 10 ISO 10993 Part 5
Processing Method	Liquid Injection Molding (LIM)

Physical	Nominal Value	Unit
Specific Gravity	1.13	g/cm³

Hardness	Nominal Value	Unit
Durometer Hardness	52

Elastomers	Nominal Value	Unit
Tensile Stress (100% Strain)	1.97	MPa
Tensile Strength	11.8	MPa
Tensile Elongation (Break)	530	%
Tear Strength ¹	39.9	kN/m
Compression Set (180°C, 22 hr)	8.0	%

Thermoset	Nominal Value	Unit
Shelf Life (32°C)	26	wk
Post Cure Time (200°C)	4.0	hr

Additional Information
Press / Post Cure: Press/Post

Uncured Properties	Nominal Value	Unit
Curing Time	0.083	hr

Note Message
1 .	B mould

Resin Grade	Manufacturer	Category	Trademark
Sylvin 8200-68 Clear 876	Sylvin Technologies Incorporated	PVC, Flexible	Sylvin
Nypol® PA B3 G60 NTLA010 NT334	Petropol Industry and Trade of Polymers LTDA	Nylon 6	Nypol® PA
ALFATER XL® A50I 3EF0001	ALBIS PLASTIC GmbH	TPV	ALFATER XL®
HAIPLEN H50 C4	Taro Plast S.p.A.	PP Homopolymer	HAIPLEN
HANWHA KH-10	Hanwha Chemical	PVC, Unspecified	HANWHA