Order Products : sales@su-jiao.com

Shin-Etsu Elastomer KEG-2000-60A/B

Category:	Silicone Rubber, HTV , Silicone Rubber, HTV
Manufacturer:	Shin-Etsu Silicones of America
Trademark:	Shin-Etsu Elastomer
Fillers:	-
Ports:	Qinzhou, Shekou, Shanghai, Ningbo
Delivery Terms	FOB, CIF, DAP, DAT, DDP
PDF:	d3VLDG_Shin-Etsu-Elastomer-KEG-2000-60A-B.pdf
PRICE:	Order Products email sales@su-jiao.com

Wechat: WECHAT

Message
Shin-Etsu KEG2000-60 is a fast cure type liquid injection molding silicone. It is supplied as two components which are mixed in a 1:1 ratio to ensure easy and accurate blending. The viscosity of KEG2000-60 is low enough to allow easy pumping through most injection molding systems. High tear strength Rapid cure time at elevated temperature Long pot life at room temperature Typical Applications O-Rings Diaphragms Capping Rubber Rollers Connector packaging Other electrical parts ClassVI certification

Message

Shin-Etsu KEG2000-60 is a fast cure type liquid injection molding silicone. It is supplied as two components which are mixed in a 1:1 ratio to ensure easy and accurate blending. The viscosity of KEG2000-60 is low enough to allow easy pumping through most injection molding systems.

High tear strength

Rapid cure time at elevated temperature

Long pot life at room temperature

Typical Applications

O-Rings

Diaphragms

Capping

Rubber Rollers

Connector packaging

Other electrical parts

ClassVI certification

General Information
Features	Low viscosity Workability, good Fast curing Good tear strength
Uses	Electrical components Diaphragm Roller Shield Connector
Agency Ratings	FDA not rated USP Class VI
Processing Method	Liquid Injection Molding (LIM)

Physical	Nominal Value	Unit
Specific Gravity	1.13	g/cm³

Hardness	Nominal Value	Unit
Durometer Hardness	58

Elastomers	Nominal Value	Unit
Tensile Stress (100% Strain)	2.46	MPa
Tensile Strength	10.5	MPa
Tensile Elongation (Break)	470	%
Tear Strength ¹	45.0	kN/m
Compression Set (180°C, 22 hr)	9.0	%

Thermoset	Nominal Value	Unit
Shelf Life (32°C)	26	wk
Post Cure Time (200°C)	4.0	hr

Additional Information
Press / Post Cure: Press/Post

Uncured Properties	Nominal Value	Unit
Curing Time	0.083	hr

Note Message
1 .	B mould

Resin Grade	Manufacturer	Category	Trademark
Radilon® S 35L 100 NAT	Radici Plastics	Nylon 6	Radilon®
TECHNYL® A 218 MZ15 V25 BLACK 31 N	Solvay Engineering Plastics	Nylon 66	TECHNYL® A
Daelim Po1y® PP-241W	DAELIM INDUSTRIAL CO., LTD.	PP Impact Copolymer	Daelim Po1y®
FERREX® GPP30CS74UL BLUE	Ferro Corporation	PP Copolymer	FERREX®
HOPELEX PCG-2205	Lotte Chemical Corporation	PC	HOPELEX