Order Products : sales@su-jiao.com
Osterlene® LD-13.5-918
| Category: | LDPE , Low Density Polyethylene |
| Manufacturer: | Osterman & Company |
| Trademark: | Osterlene® |
| Fillers: | - |
| Ports: | Qinzhou, Shekou, Shanghai, Ningbo |
| Delivery Terms | FOB, CIF, DAP, DAT, DDP |
| PDF: | cQRDKQ_Osterlene-LD-13-5-918.pdf  |
| PRICE: | Order Products email sales@su-jiao.com |
Wechat:
| Message |
|---|
|
LD-13.5-918 is an extrusion coating resin especially recommended for high-speed, light weight coating applications. The resin can be drawn to a 3 lb/ream coating weight at line speeds in excess of 1500 fpm with minimum neck-in and no edge weave. LD-13.5-918 meets the requirements of the Food and Drug Administration, 21 CFR Section 177.1520 regulations. Specific limitations may apply. |
| General Information | |
|---|---|
| Features |
|
| Uses |
|
| Agency Ratings |
|
| Forms |
|
| Processing Method |
|
| Physical | Nominal Value | Unit | Test Method |
|---|---|---|---|
| Density | 0.918 | g/cm³ | ASTM D1505 |
| Melt Mass-Flow Rate (MFR) (190°C/2.16 kg) | 14 | g/10 min | ASTM D1238 |
| Hardness | Nominal Value | Unit | Test Method |
|---|---|---|---|
| Durometer Hardness (Shore D) | 50 | ASTM D2240 |
| Mechanical | Nominal Value | Unit | Test Method |
|---|---|---|---|
| Tensile Strength | 11.0 | MPa | ASTM D638 |
| Tensile Elongation (Yield) | 500 | % | ASTM D638 |
| Flexural Strength | 207 | MPa | ASTM D790 |
| Thermal | Nominal Value | Unit | Test Method |
|---|---|---|---|
| Vicat Softening Temperature | 28.9 | °C | ASTM D1525 |
| Extrusion | Nominal Value | Unit | |
|---|---|---|---|
| Melt Temperature | 310 - 327 | °C |
| Extrusion instructions |
|---|
| It is recommended that a melt temperature of 590 - 620°F be used for light-weight coating applications in conjunction with electrostatic, flame or chemical priming to insure good adhesion.The maximum recommended melt temperature for LD-13.5-918 is 625°F. |
| Resin Grade | Manufacturer | Category | Trademark |
|---|---|---|---|
| SCANAMID 6 B12^ QF2515 | Polykemi AB | Nylon 6 | SCANAMID 6 |
| EPO-TEK® H70E-2 | Epoxy Technology Inc. | Epoxy | EPO-TEK® |
| HyTemp® AR12B | Zeon Chemicals L.P. | Acrylic, Unspecified | HyTemp® |
| Iupital® F40-03 | Mitsubishi Engineering-Plastics Corp | Acetal (POM) Copolymer | Iupital® |
| Dryflex® SE 55A201 | ELASTO | TPE | Dryflex® |
