Order Products : sales@su-jiao.com

VECTOR® 4215

Category:	SIS+SI , Styrene Isoprene Styrene + SI Block Copolymer
Manufacturer:	Dexco Polymers LP
Trademark:	VECTOR®
Fillers:	-
Ports:	Qinzhou, Shekou, Shanghai, Ningbo
Delivery Terms	FOB, CIF, DAP, DAT, DDP
PDF:	Z501Uf_VECTOR-4215.pdf
PRICE:	Order Products email sales@su-jiao.com

Wechat: WECHAT

Message
Blend of SIS triblock and SI diblock copolymer Medium styrene copolymer Outstanding thermal stability Outstanding melt processability Complies with U.S. FDA 21 CFR 177.1810; Consult the regulations for complete details VECTOR 4215 is a blend of SIS triblock and SI diblock copolymer with a styrene content of 30%. Its higher styrene content leads to higher modulus, higher temperature end-use, and enhanced creep resistance. It is designed for use in hot melt adhesive applications such as disposable adhesives requiring superior cohesive strength and heat resistance along with low creep compliance.

Message

Blend of SIS triblock and SI diblock copolymer

Medium styrene copolymer

Outstanding thermal stability

Outstanding melt processability

Complies with U.S. FDA 21 CFR 177.1810; Consult the regulations for complete details

VECTOR 4215 is a blend of SIS triblock and SI diblock copolymer with a styrene content of 30%. Its higher styrene content leads to higher modulus, higher temperature end-use, and enhanced creep resistance. It is designed for use in hot melt adhesive applications such as disposable adhesives requiring superior cohesive strength and heat resistance along with low creep compliance.

General Information
Features	Block Copolymer Workability, good Good creep resistance Heat resistance, high Thermal stability, good
Uses	Adhesive
Agency Ratings	FDA 21 CFR 177.1810
Forms	Particle

Physical	Nominal Value	Unit	Test Method
Specific Gravity	0.940	g/cm³	ASTM D792
Melt Mass-Flow Rate (MFR) (200°C/5.0 kg)	9.0	g/10 min	ASTM D1238

Hardness	Nominal Value	Unit	Test Method
Durometer Hardness (Shore A, 1 sec)	58		ASTM D2240

Elastomers	Nominal Value	Unit	Test Method
Tensile Stress (300% Strain)	3.45	MPa	ASTM D412
Tensile Strength (Yield)	17.9	MPa	ASTM D412
Tensile Elongation (Break)	1000	%	ASTM D412

Additional Information
Styrene, Dexco Test Method: 30% Wt.Diblock Content, Dexco Test Method: 18% Wt.Ash, ASTM D1416: 0.3% Wt.

Resin Grade	Manufacturer	Category	Trademark
RTP 200 D AR 10	RTP Company	Nylon 612	RTP
Hanwha Total PP GH42	HANWHA TOTAL PETROCHEMICALS Co., Ltd.	PP, High Crystal	Hanwha Total PP
Mafill® CR CTE 5344	Ravago Group	PP Copolymer	Mafill®
Plasmer 2055N/1002	HYUNDAI EP Co., Ltd.	TPE	Plasmer
ALPERFORM PC LD	ALBIS PLASTIC GmbH	PC	ALPERFORM