Order Products : sales@su-jiao.com
Epolene® C-18
| Category: | LDPE , Low Density Polyethylene |
| Manufacturer: | Westlake Chemical Corporation |
| Trademark: | Epolene® |
| Fillers: | - |
| Ports: | Qinzhou, Shekou, Shanghai, Ningbo |
| Delivery Terms | FOB, CIF, DAP, DAT, DDP |
| PDF: | RqwBrV_Epolene-C-18.pdf  |
| PRICE: | Order Products email sales@su-jiao.com |
Wechat:
| Message |
|---|
| Epolene C-18 is a branched low density polyethylene modified with maleic anhydride. It is useful as a base polymer for adhesives and coatings, color concentrate dispersion, and applications requiring compatibility with polyamide. Coatings produced with Epolene C-18 exhibit high gloss, low moisture vapor transmission rates, grease resistance, and good heat seal ability. In hot melt adhesives, the maleic anhydride modification allows for improved adhesion, greater filler tolerance, broader capabilities, and improved aging properties. |
| General Information | |
|---|---|
| Features |
|
| Uses |
|
| Forms |
|
| Physical | Nominal Value | Unit | |
|---|---|---|---|
| Acid Number | 2.00 | mg KOH/g | |
| Molecular Weight 1 | 15000 |
| Thermal | Nominal Value | Unit | Test Method |
|---|---|---|---|
| Ring and Ball Softening Point | 101 | °C | ASTM E28 |
| Additional Information | Nominal Value | Unit | Test Method |
|---|---|---|---|
| Penetration Hardness 2(25°C) | 400 | mm | ASTM D5 |
| Fill Analysis | Nominal Value | Unit | Test Method |
|---|---|---|---|
| Melt Viscosity | |||
| 190°C | 1550 | mPa·s | |
| 125°C | 7750 | mPa·s |
| Note Message | |
|---|---|
| 1 . | Molecular weight measured via Gel Permeation Chromatography (GPC) using polystyrene standards |
| 2 . | Needle under 100-g load for 5s, tenths of mm |
| Resin Grade | Manufacturer | Category | Trademark |
|---|---|---|---|
| PrimoPrene 75A-1000 | KMI Group Inc. | TPV | PrimoPrene |
| Shin-Etsu Elastomer SFX-7961A-6 | Shin-Etsu Silicones of America | Fluoro Si | Shin-Etsu Elastomer |
| StarFlex P 7370-9000 | STAR Thermoplastic Alloys & Rubbers, Inc. | TPE | Starflex |
| Akulon® K225-KS | DSM Engineering Plastics | Nylon 6 | Akulon® |
| TECACOMP® PEEK 150 GF30 natural 9592 | Ensinger GmbH | PEEK | TECACOMP® |
