Evoprene™ G 3293

Category: SEBS , Styrene Ethylene Butylene Styrene Block Copolymer
Manufacturer: AlphaGary
Trademark: Evoprene™ G
Fillers: -
Ports: Qinzhou, Shekou, Shanghai, Ningbo
Delivery Terms FOB, CIF, DAP, DAT, DDP
PDF: QbRxF9_Evoprene-G-3293.pdf
PRICE: ​Order Products​ email   sales@su-jiao.com
Wechat: WECHAT
Message
A very wide range of Evoprene™ G compounds is available for applications in all sectors of industry. The range is based on the widely specified SEBS (styrene - ethylene butylene - styrene) and related hydrogenated block copolymers. These polymers are fully saturated, i.e. there are no double bonds present so the resistance to oxidation, ozone and general outdoor weathering is excellent. For extended outdoor use, however, it is important to ensure additional UV stabilization is specified, especially in light colours. Evoprene™ G grades are used in service over a wide temperature range (see notes below) but each component should be fully assessed for temperature resistance before being put into service.
General Information
Features
  • Block Copolymer
  • Food Contact Acceptable
  • Good Colorability
  • Good Electrical Properties
  • Good Processability
  • Good Weather Resistance
  • Oxidation Resistant
  • Ozone Resistant
  • Recyclable Material
Uses
  • Outdoor Applications
Agency Ratings
  • EU Food Contact, Unspecified Rating
  • FDA Food Contact, Unspecified Rating
RoHS Compliance
  • Contact Manufacturer
Appearance
  • Clear/Transparent
Forms
  • Pellets
Processing Method
  • Coextrusion
  • Injection Molding
PhysicalNominal ValueUnitTest Method
Density 0.880g/cm³ISO 2782
HardnessNominal ValueUnitTest Method
Shore Hardness (Shore A)43ISO 868
ElastomersNominal ValueUnitTest Method
Tensile Stress (100% Strain)1.20MPaISO 37
Tensile Stress (Yield)5.80MPaISO 37
Tensile Elongation (Break)600%ISO 37
Tear Strength 121kN/mISO 34-1
Compression Set (22°C, 72 hr)46%ISO 815
ElectricalNominal ValueUnit
Volume Resistivity 1.0E+15ohms·cm
Electric Strength 24 to 28kV/mm
Additional InformationNominal ValueUnitTest Method
M-S Flow 1.67MPaInternal Method
InjectionNominal ValueUnit
Suggested Max Regrind 20%
Rear Temperature 170 to 190°C
Middle Temperature 170 to 190°C
Front Temperature 170 to 190°C
Nozzle Temperature 170 to 190°C
Processing (Melt) Temp 250°C
Mold Temperature 30.0 to 60.0°C
Injection Rate Fast
Vent Depth 0.020 to 0.050mm
Note Message
1 .Method Ba, Angle (Unnicked)
Resin Grade Manufacturer Category Trademark
RTP 203 TFE 15 RTP Company Nylon 66 RTP
Propafilm™ FFC100 Innovia Films Ltd. PP Alloy Propafilm™
Geon™ Vinyl Rigid Molding M3815 PolyOne Corporation PVC, Rigid Geon™ Vinyl Rigid Molding
IROGRAN® A 85 E 5719 FCM Huntsman Corporation TPU-Polyester IROGRAN®
Hostacom TRC 411N C11408 LyondellBasell Industries PP, Unspecified Hostacom