Order Products : sales@su-jiao.com

Shin-Etsu Elastomer KE-1950-50A/B

Category:	Silicone Rubber, HTV , Silicone Rubber, HTV
Manufacturer:	Shin-Etsu Silicones of America
Trademark:	Shin-Etsu Elastomer
Fillers:	-
Ports:	Qinzhou, Shekou, Shanghai, Ningbo
Delivery Terms	FOB, CIF, DAP, DAT, DDP
PDF:	EMGB0Z_Shin-Etsu-Elastomer-KE-1950-50A-B.pdf
PRICE:	Order Products email sales@su-jiao.com

Wechat: WECHAT

WECHAT

Message

Shin-Etsu KE-1950-50 is a liquid injection molding silicone. It is supplied as two components which are mixed in a 1:1 ratio to ensure easy and accurate blending. The viscosity of KE-1950-50 is low enough to allow easy pumping through most injection molding systems.

Rapid cure time at elevated temperature.

Long pot life at room temperature.

Typical Applications

O-rings. - Diaphragms.

Capping.

Rubber rollers.

Connector packings.

Other electrical parts

General Information
Features	Low viscosity Workability, good Fast curing
Uses	Electrical/Electronic Applications Electrical components Diaphragm Roller Shield
Agency Ratings	FDA not rated USP Class VI
Forms	Liquid
Processing Method	Liquid Injection Molding (LIM)

Physical	Nominal Value	Unit
Specific Gravity	1.13	g/cm³

Hardness	Nominal Value	Unit
Durometer Hardness	52

Elastomers	Nominal Value	Unit
Tensile Stress (100% Strain)	1.67	MPa
Tensile Strength	9.30	MPa
Tensile Elongation (Break)	550	%
Tear Strength ¹	39.9	kN/m
Compression Set (180°C, 22 hr)	8.0	%

Thermoset	Nominal Value	Unit
Post Cure Time (200°C)	4.0	hr

Additional Information
Press Cure / Post Cure: Press/Post

Uncured Properties	Nominal Value	Unit
Curing Time	0.083	hr

Note Message
1 .	B mould

Resin Grade	Manufacturer	Category	Trademark
THERMOLAST® K TF2CGN (Series: FC)	KRAIBURG TPE	TPE	THERMOLAST® K
Toughblend® PP-1201	Colour Image Plastic Compound Sdn. Bhd. (CIPC)	PP, Unspecified	Toughblend®
Trithene® TS 7003	Petroquimica Triunfo	LDPE	Trithene®
EL-Lene™ H5615F	SCG Chemicals Co., Ltd.	HDPE	EL-Lene™
HiFill® PA6 0266 B	Techmer Engineered Solutions	Nylon 6	HiFill®