Order Products : sales@su-jiao.com

Shin-Etsu Elastomer KEG-2000-30A/B

Category:	Silicone Rubber, HTV , Silicone Rubber, HTV
Manufacturer:	Shin-Etsu Silicones of America
Trademark:	Shin-Etsu Elastomer
Fillers:	-
Ports:	Qinzhou, Shekou, Shanghai, Ningbo
Delivery Terms	FOB, CIF, DAP, DAT, DDP
PDF:	3DW9VU_Shin-Etsu-Elastomer-KEG-2000-30A-B.pdf
PRICE:	Order Products email sales@su-jiao.com

Wechat: WECHAT

Message
Shin-Etsu KEG-2000-30 is a liquid injection molding silicone. It is supplied as two components which are mixed in a 1:1 ratio to ensure easy and accurate blending. The viscosity of KEG-2000-30 is low enough to allow easy pumping through most injection molding systems. Rapid cure time at elevated temperature. Long pot life at room temperature. Typical Applications O-rings. Diaphragms. Capping. Rubber rollers. Connector packings. Other electrical parts.

Message

Shin-Etsu KEG-2000-30 is a liquid injection molding silicone. It is supplied as two components which are mixed in a 1:1 ratio to ensure easy and accurate blending. The viscosity of KEG-2000-30 is low enough to allow easy pumping through most injection molding systems.

Rapid cure time at elevated temperature.

Long pot life at room temperature.

Typical Applications

O-rings.

Diaphragms.

Capping.

Rubber rollers.

Connector packings.

Other electrical parts.

General Information
Features	Low viscosity Workability, good Fast curing
Uses	Electrical components Diaphragm Roller Shield Connector
Agency Ratings	FDA not rated USP Class VI
Processing Method	Liquid Injection Molding (LIM)

Physical	Nominal Value	Unit
Specific Gravity	1.10	g/cm³

Hardness	Nominal Value	Unit
Durometer Hardness	32

Elastomers	Nominal Value	Unit
Tensile Stress (100% Strain)	0.703	MPa
Tensile Strength	8.50	MPa
Tensile Elongation (Break)	750	%
Tear Strength ¹	25.0	kN/m
Compression Set (180°C, 22 hr)	6.0	%

Thermoset	Nominal Value	Unit
Shelf Life (32°C)	26	wk
Post Cure Time (200°C)	4.0	hr

Additional Information
Press / Post Cure: Press/Post

Uncured Properties	Nominal Value	Unit
Curing Time	0.083	hr

Note Message
1 .	B mould

Resin Grade	Manufacturer	Category	Trademark
MIDILENA III HDPE2200J	ROMPETROL PETROCHEMICALS S.R.L.	HDPE	MIDILENA III
Axiall PVC CL-6400	Axiall Corporation	PVC, Rigid	Axiall PVC
ENFLEX V1075A BLK UV	ENPLAST Americas, a Ravago Group Company	TPV	ENFLEX
KOPPS® S13G40	Kolon Plastics, Inc.	PPS	KOPPS®
Keliren® CM301	Hangzhou Keli Chemical Co., Ltd.	CPE	Keliren®