Order Products : sales@su-jiao.com

DOWLEX™ IP 20

Category:	LLDPE , Polyethylene Resin
Manufacturer:	The Dow Chemical Company
Trademark:	DOWLEX™
Fillers:	-
Ports:	Qinzhou, Shekou, Shanghai, Ningbo
Delivery Terms	FOB, CIF, DAP, DAT, DDP
PDF:	2GnXcz_DOWLEX-IP-20.pdf
PRICE:	Order Products email sales@su-jiao.com

Wechat: WECHAT

Message
DOWLEX IP 20 Polyethylene Resin is a Linear Low Density Polyethylene produced at Dow and it is intended for injection molding applications. This resin presents superior properties compared to a Polyethylene of similar melt index and density. Its main characteristics are: high stiffness, good resistance at low temperatures, exceptional gloss and reduced warp in large pieces Main Applications: Injection Molded parts Food ware and house ware Toys Boxes and trays Caps and lids Carrier resin for compounding (masterbatches) Complies with: U.S. FDA 21 CFR 177.1520(c )3.2a Europe Commission Regulation (EU) No 10/2011 Consult the regulations for complete details.

Message

DOWLEX IP 20 Polyethylene Resin is a Linear Low Density Polyethylene produced at Dow and it is intended for injection molding applications. This resin presents superior properties compared to a Polyethylene of similar melt index and density. Its main characteristics are: high stiffness, good resistance at low temperatures, exceptional gloss and reduced warp in large pieces

Main Applications:

Injection Molded parts

Food ware and house ware

Toys

Boxes and trays

Caps and lids

Carrier resin for compounding (masterbatches)

Complies with:

U.S. FDA 21 CFR 177.1520(c )3.2a

Europe Commission Regulation (EU) No 10/2011

Consult the regulations for complete details.

General Information
Agency Ratings	EU No 10/2011 FDA 21 CFR 177.1520(c) 3.2a
Forms	Pellets

Physical	Nominal Value	Unit	Test Method
Specific Gravity	0.926	g/cm³	ASTM D792
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)	20	g/10 min	ASTM D1238
Environmental Stress-Cracking Resistance (50°C, 100% Igepal, F50)	8.00	hr	ASTM D1693

Hardness	Nominal Value	Unit	Test Method
Durometer Hardness (Shore D)	63		ASTM D2240

Mechanical	Nominal Value	Unit	Test Method
Tensile Strength			ASTM D638
Yield	15.0	MPa
Break	9.00	MPa
Tensile Elongation (Break)	130	%	ASTM D638
Flexural Modulus	528	MPa	ASTM D790

Injection	Nominal Value	Unit
Processing (Melt) Temp	190 to 230	°C
Mold Temperature	5.00 to 30.0	°C

Resin Grade	Manufacturer	Category	Trademark
RJM SA102-HL	RJM International, Inc.	PC	RJM
ALCOM® PC 740/171 GY1127-04LD	ALBIS PLASTIC GmbH	PC	ALCOM® PC
Latamid 66 H-V0	LATI S.p.A.	Nylon 66	Latamid
Plaslube® PP GF30 TL15	Techmer Engineered Solutions	PP, Unspecified	Plaslube®
Sylvin 6034-85 Yellow 4208	Sylvin Technologies Incorporated	PVC, Unspecified	Sylvin